NSK

RHP Self-Lube® 1135-1.7/16CG Bearing Insert With Snap Ring and (2) Integral Set Screw Locks

Item #
1135-1.7/16CG NSK
$168.32
RHP Self-Lube® 1135-1.7/16CG Bearing Insert With Snap Ring and (2) Integral Set Screw Locks, 35 mm Dia Bore, 72 mm OD, 42.9 mm W, 25700 N Dynamic/15300 N Static Load

This type of ball bearing is recommended when alignment of the shaft and housing is difficult and the shaft may flex. The outer ring has a spherical raceway and its center of curvature coincides with that of the bearing; therefore, the axis of the inner ring, balls and cage can deflect to some extent around the bearing center. Pressed steel cages are usually used. Since the contact angle is small, the axial load capacity is low. The permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees) under normal loads.
However, depending on the surrounding structure, such an angle may not be possible.

Important Documents

More Information
Manufacturer NSK
Ball Bearing Type Self-Aligning Ball Bearing
Bore Diameter 36.513 mm
Outer Diameter 72 mm
Overall Width 42.9 mm
Search engine powered by ElasticSuite